NLG Archives Archives Wayback MachineĬontact Us NLG Shop 928 754-4147 Email Us 1788 Highway 95 30 BHC City AZ 86442 in your hands.īring it over to a well lit bench and take good photos of the guts of it.especially where the pawls to the gears are and where the melted orange goop is.įrom there, we'll be able to determine what you can do next for sure! Those are for the handle contact and tells the MPU that the handle has been engaged for a spin.pull those two connectors off the switch tabs and place aside. Once those nuts are removed, slowly pull out the entire mech and you will have two more connectors attached to a small microswitch. The bolts run thru the mech and out to the round metal plate outside that surrounds the handle shaft to the mech. Now, using a ratchet wrench with an extension and socket, there will be 3 nuts you need to remove. That is for the solenoid pawl release.pull those two connectors off the tabs and move aside. Inside the cabinet, there 's two wire connectors way on top in the back corner on top of the handle mech. Once the bolt is out, pull out the handle and put the cap aside. First, you need to stick an Allen key under the handle into the hole of the cap and remove the handle bolt.
